Home > Knowledge > Content
Operation and attention of shrink wrapping machine
Nov 15, 2018

1, shrinkage packaging machine and winding machine the same due to the power consumption is very large, so the power of the input power supply must be greater than the nominal power on the Shrink nameplate, otherwise easy to burn the line or electrical components.

2, like the baler machine must be reliably grounded to protect personal safety.

3, each machine is accompanied by a cable connected to the power supply, its end head lead part with the identification symbol of the power supply, must be properly connected, illegal operation may lead to electric shock.

4, when the machine specified voltage of three-phase 380V power supply, must be entered at the same time 0 lines, that is, the standard three-phase four-wire other packaging equipment is also so like a vacuum packaging machine.

Otherwise, the machine will not work properly, and it is easy to burn internal electrical components.

5, the machine must be installed horizontally, otherwise the service life of the electric heating pipe will be shortened.

For a machine transmitted by a mesh belt, its tilt mounting will cause the conveyor belt to deviate from the center.

6, the machine continuous use for more than three months, should be the shrinkage chamber of the temperature-resistant wire inspection, according to its aging degree, as appropriate replacement.

7, when the machine works, the operator's palm and other parts are not allowed to contact with the operating parts of the machine, especially the internal temperature of the shrinkage chamber is extremely high, very easy to burn.

8, packaging work after the end, should first turn off the heating switch, so that the conveyor motor and fan motor continue to run for about 10 minutes, and then cut off the entire power supply.


Related Industry Knowledge